Product brief introduction
This product is of high purity solvents containing additive products, mainly used for cleaning electrical equipment fault caused by oil, iron, carbon and other dirt, can prolong the service life of electrical equipment; prevention of equipment failure, reduce the risk of fire, to ensure the normal operation of electrical equipment.
●Good insulation properties, high voltage above 25KV.
●To constitute the various types of electrical equipment safety and no corrosion of materials.
●Charged cleaning, in the cleaning process does not affect the performance of electrical equipment.
●Low odor, can evaporate completely, without any residue.
●Higher ignition point, suitable for field operation.
●Electrical equipment: used for cleaning motor, generator, power distribution switch cabinet, electrical equipment, power distribution room equipment, large electromagnetic valve, switch, automatic switch, electric welding machine, contact, small power hand tools, cleaning the electrical equipment when not on the electrical equipment insulation effect.
●Mechanical equipment: machinery and equipment for cleaning, degreasing, such as hydraulic machinery hydraulic cylinder, various filters, gear, bearing, the hinge mechanism and other mechanical equipment and all kinds of metal parts.
Method of use
●Spray washing: You can use special 161# spray gun. The use of 161# spray gun without an external 0.4~0.6MP compressed air spray gun, 161# connecting compressed air, we should first check whether there is any water in the air, usually with several methods to confirm the following:
①Sky is put to observe if there is fog.
②To dry cement jet of compressed air, check whether the water mark.
③Distance to the palm of your hand sprayed compressed air, feel the moisture.
If the compressed air with water, will affect the cleaning effect, and even has the potential to make insulation decline, but not charged cleaning.
The use of ES-312 cleaning should first before using compressed air to purge attached to the electrical equipment of surface dust and impurities, and then use 161# airbrush straw inhaled ES-312 cleaning, cleaning should be finished dry or dry.
The three step: cleaning wind -- ES-312-- dry cleaning
●Immersion method: for cleaning small motor parts or all kinds of machinery parts is directly soaked in the solution containing ES-312 container, after several minutes, remove, dry or dry. For lubricated parts please grease.
●Scrubbing and washing method: cannot use immersion and spray washing cleaning mechanical and electrical equipment, can be directly used for ES-312 to scrub or scrub brush. After washing, drying or drying.
●Aerosol cans steel packaging direct jet cleaning.
Matters needing attention
●Please do not use it near a naked flame, at 40℃storage ventilation.
●Not a long time in contact with skin and a large number of inhaled volatile gases, if inadvertently splashed into eyes, please rinse with water.
●Aerosol cans products after use, empty cans with internal pressure, must not be thrown into the fire and burned.
450ML aerosol cans packaging
200L/ 20L/ barrel, barrel drum